I'm new to this sort of thing so if anyone has an answer can you please write it so its easy for me to understand, I'm definitely not a plumber!
I recently bled the radiators in my house, one of them was completely full of air so I bled it completely, this dropped the pressure in the system. I only bled small amounts at a time and then re pressurised before bleeding again all in the same afternoon.
Since then the boiler has not been heating water well at all. The flame comes on but goes off again quickly and doesnt heat the water. The only way so far I have found to get hot water from the taps is to run them very slowly.
the boiler is a gas combi boiler with no emursion or tank.
Sorry for my spelling and thanks for any help.
I recently bled the radiators in my house, one of them was completely full of air so I bled it completely, this dropped the pressure in the system. I only bled small amounts at a time and then re pressurised before bleeding again all in the same afternoon.
Since then the boiler has not been heating water well at all. The flame comes on but goes off again quickly and doesnt heat the water. The only way so far I have found to get hot water from the taps is to run them very slowly.
the boiler is a gas combi boiler with no emursion or tank.
Sorry for my spelling and thanks for any help.