Broag Rameha Avanta 28c codes

Discussion in 'Plumbing and Central Heating' started by ambuman, 29 May 2015.

  1. ambuman

    ambuman

    Joined:
    29 May 2015
    Messages:
    2
    Thanks Received:
    0
    Location:
    Lancashire
    Country:
    United Kingdom
    Broad Rameha Avanta 28c. I have the above boiler, just 5 years old and out of guarantee. Code E13 has been occuring quite a bit. according to the engeneers it seems like a new heat exchanger. I would like a second opinion from someone familiar with this boiler before spending a load of money. Perhaps a new boiler is the answer. Thanks.javascript:emoticon(':cry:')
     
  2. Sponsored Links
  3. Boilerman2

    Boilerman2

    Joined:
    10 Jun 2009
    Messages:
    5,225
    Thanks Received:
    1,015
    Location:
    Suffolk
    Country:
    United Kingdom
    It is most likely that the Heat Exchanger will need to be replaced as the embedded heat sensor cannot be replaced in isolation. it would be worth looking at the strainer built into the hydroblock as this can restrict water flow through the HEX a causes overheat problems usually during a Hot water demand ;)
     
  4. ambuman

    ambuman

    Joined:
    29 May 2015
    Messages:
    2
    Thanks Received:
    0
    Location:
    Lancashire
    Country:
    United Kingdom
    Thanks a lot for a quick reply. I shall pass this one to my engineer and see if that cures the problem. It does seem to happen mostly when the heating is on and the hot water tap is used. i shall report back.
     
  5. DIYnot Local

    DIYnot Local

    Joined:
    3 Sep 2019
    Country:
    United Kingdom

    If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

    Select the supplier or trade you require, enter your location to begin your search.


    Are you a trade or supplier? You can create your listing free at DIYnot Local

     
Loading...

Share This Page