Hi all,
I need to replace my oven. It's currently a double built-under oven standing on 4 short legs, and situated at a 45 degree angle into a corner with a ceramic hob over the top of it. Rather like this:
Ideally, I would like to replace this oven with something similar, one that stands on feet and just has a couple of screws into the trim either side to steady it, so can anyone recommend a manufacturer and built-under model that has legs and/or feet? Can't seem to see this information on any of the websites.
The problem I have is that the existing carcass surrounding the oven isn't much of a housing... the panels at the sides of the oven only go back approximately 20cm so are unable to have any full depth supporting rails attached to them, and the width of the opening where the oven sits is a bit under 60cm wide so I cannot slide a new housing into the gap. I don't really want to have to start remodelling the trim and surround when it would be so simple to just slide a new oven in.
Many thanks for any advice.
I need to replace my oven. It's currently a double built-under oven standing on 4 short legs, and situated at a 45 degree angle into a corner with a ceramic hob over the top of it. Rather like this:
Ideally, I would like to replace this oven with something similar, one that stands on feet and just has a couple of screws into the trim either side to steady it, so can anyone recommend a manufacturer and built-under model that has legs and/or feet? Can't seem to see this information on any of the websites.
The problem I have is that the existing carcass surrounding the oven isn't much of a housing... the panels at the sides of the oven only go back approximately 20cm so are unable to have any full depth supporting rails attached to them, and the width of the opening where the oven sits is a bit under 60cm wide so I cannot slide a new housing into the gap. I don't really want to have to start remodelling the trim and surround when it would be so simple to just slide a new oven in.
Many thanks for any advice.
Last edited: