- Joined
- 4 Jul 2015
- Messages
- 3
- Reaction score
- 0
- Country
Hi,
I have an old bath mixer tap which has a deep channel in the cold tap seat.
Since I can't get the bath out (a long story) to change the taps, I've put a plastic/silicone seat cover in and am trying to install the new tap washer/seat into the tap.
However, whatever I do I can't get the jumper out of the tap. It rotates but just won't pull out. Am I missing something? Could it be corrosion? Do I need to take apart the top section of the tap? Do I just need a bigger hammer?
Any ideas?
Paul
I have an old bath mixer tap which has a deep channel in the cold tap seat.
Since I can't get the bath out (a long story) to change the taps, I've put a plastic/silicone seat cover in and am trying to install the new tap washer/seat into the tap.
However, whatever I do I can't get the jumper out of the tap. It rotates but just won't pull out. Am I missing something? Could it be corrosion? Do I need to take apart the top section of the tap? Do I just need a bigger hammer?
Any ideas?
Paul