- Joined
- 7 Oct 2003
- Messages
- 3
- Reaction score
- 0
- Country
Hi there,
Doing a bit of sawing to remove some bad gutter down pipe and I accidentally caught the plastic coated copper pipe (BS2871) that runs through the wall from my outdoor propane cylinder.
What can I do about this can I just solder the tear out of the pipe ? liquid dripped so I shut off the gas immediately. This pipe does run through concrete (into the kitchen) and is plastic coated, it was installed prior to us buying the property. Any ideas on the best / safest course of action ?
Many thanks
Niall
Doing a bit of sawing to remove some bad gutter down pipe and I accidentally caught the plastic coated copper pipe (BS2871) that runs through the wall from my outdoor propane cylinder.
What can I do about this can I just solder the tear out of the pipe ? liquid dripped so I shut off the gas immediately. This pipe does run through concrete (into the kitchen) and is plastic coated, it was installed prior to us buying the property. Any ideas on the best / safest course of action ?
Many thanks
Niall