- Joined
- 16 Jul 2019
- Messages
- 13
- Reaction score
- 1
- Country
Hi all
Signed up in the hope of some help.
I have a newly installed (1 month ago) Worcester Bosch Combi Boiler (30i) converted from a vented system.
The problem is that the hot water cuts out after a few minutes. No errors are seen on the boiler, no reset is needed and no increase in temperature prior to it cutting out. (i.e. pilot light goes out). If nothing is done, after a minute or so the boiler will fire back up and hot water will be delivered again.
This is noticed most clearly in the shower due to time in use, but also at the kitchen sink. The only other taps in the house are the bathroom taps.
WB have come out three times and unable to figure out what's going on. Things tried:
Any thoughts would be very welcome, at the very least I can ask them to check later this week!
Thanks
Signed up in the hope of some help.
I have a newly installed (1 month ago) Worcester Bosch Combi Boiler (30i) converted from a vented system.
The problem is that the hot water cuts out after a few minutes. No errors are seen on the boiler, no reset is needed and no increase in temperature prior to it cutting out. (i.e. pilot light goes out). If nothing is done, after a minute or so the boiler will fire back up and hot water will be delivered again.
This is noticed most clearly in the shower due to time in use, but also at the kitchen sink. The only other taps in the house are the bathroom taps.
WB have come out three times and unable to figure out what's going on. Things tried:
- Temperature sensor replaced
- Control panel replaced
- Power kW reduced
- Flow restrictor replaced (the wrong one was apparently fitted to this boiler)
Any thoughts would be very welcome, at the very least I can ask them to check later this week!
Thanks