I should have stuck with my original intention to get a basin with seperate taps, now I'm stuck with these tails, I think they are intended to be soldered and I don't feel competent,
They are 9" long, can I shorten them and then bend them slightly when they are fixed to the tap? If I bent them before fixing I wouldn't know where the bend would finish up.
Then I'm thinking I could use push fit, flexible pipes.
Is this a sound idea?
Thanks for any advice....regards....Mike
They are 9" long, can I shorten them and then bend them slightly when they are fixed to the tap? If I bent them before fixing I wouldn't know where the bend would finish up.
Then I'm thinking I could use push fit, flexible pipes.
Is this a sound idea?
Thanks for any advice....regards....Mike