Just finished putting up some boards and noticed that two of them are not completely flush where they meet - the ends are touching but the face of one of them (toward the bottom of the board only) is slightly raised compared to the other one (we are talking 2/3 mm here)
Is it possible to file/sand the edge of the board to smooth out the joint even though I know it wont smooth out the whole wall - or will taping / prepping / skimming cover the worst of it
Ta
Is it possible to file/sand the edge of the board to smooth out the joint even though I know it wont smooth out the whole wall - or will taping / prepping / skimming cover the worst of it
Ta