Hi everyone,
I am sure these types of questions have been asked before.
I am fitting an electric shower in. I am putting in 10mm cable from the Main board to a pull switch with neon and little off and on sign.
Then continuing the 10mm cable to the shower. The shower will be 8.5kw.
Firstly can i use a 32amp mcb as a temp measure, until i get a 40 amp? What are the implications of this.
More importantly at present i can only get hold of a 50amp mcb. if i put this instead of a 40amp is this ok??
Any advice will be much appreciated.
Thanks in advance
Kam
I am sure these types of questions have been asked before.
I am fitting an electric shower in. I am putting in 10mm cable from the Main board to a pull switch with neon and little off and on sign.
Then continuing the 10mm cable to the shower. The shower will be 8.5kw.
Firstly can i use a 32amp mcb as a temp measure, until i get a 40 amp? What are the implications of this.
More importantly at present i can only get hold of a 50amp mcb. if i put this instead of a 40amp is this ok??
Any advice will be much appreciated.
Thanks in advance
Kam