Sometimes when I make wooden gates, despite doing double angle braces, they'll end up twisted/warped(not sagging). Like if the latch is at the top, if it's flush up top, down at the bottom it's either too further in or is sticks out.
Are they are tips on a) how to prevent it, or b) how to fix it. I recently made a gate just like this http://www.quinneys.com/wp-content/uploads/2015/11/image003.jpg (this is not my gate) and it ended up twisted on the latch side. It looks a dog when it's not flush all the way down.
Are they are tips on a) how to prevent it, or b) how to fix it. I recently made a gate just like this http://www.quinneys.com/wp-content/uploads/2015/11/image003.jpg (this is not my gate) and it ended up twisted on the latch side. It looks a dog when it's not flush all the way down.
Last edited: