Hi,
Can you help me folks!
I’ve some experience of the new type flushes but not these. It’s a wall mounted plastic cistern sitting well above the pan. It’s taking ages to fill and water is dripping from below the green plastic part when I assume it’s meant to flow out of the small white spout.
I think it’s fed from cold water tank so probably not great pressure but I need to fix/improve matters. Got a well painted in isolation valve going to cistern but I’m sure I’ll get the water off one way or another. What’s my best bet, can you still replace this with new or might it be some sort of washer/seal issue?
I’ll probably come back tomorrow, try to get water off, then open the green part up.
Advice appreciated.
Can you help me folks!
I’ve some experience of the new type flushes but not these. It’s a wall mounted plastic cistern sitting well above the pan. It’s taking ages to fill and water is dripping from below the green plastic part when I assume it’s meant to flow out of the small white spout.
I think it’s fed from cold water tank so probably not great pressure but I need to fix/improve matters. Got a well painted in isolation valve going to cistern but I’m sure I’ll get the water off one way or another. What’s my best bet, can you still replace this with new or might it be some sort of washer/seal issue?
I’ll probably come back tomorrow, try to get water off, then open the green part up.
Advice appreciated.