Flame fault

[firedrillphil]

Hi

I have a Baxi Combi 80e boiler, the warning light is telling me I have a flame fault. When I moved ion to the house the boiler was already installed so I dont have a manual?

Any ideas how to fix it?

Cheers

 

[namsag]

Try turning power off for few mins then when you turn it back on the knob on left hand side turn it to R postion for 3 seconds then let it go back to tap/rad position and it should fire up.. if gas is on

 

[firedrillphil]

no luck. its fires up for about 5 seconds and then cuts out and the flame fault light comes back on

 

[Agile]

Lack of flame detection!

Might be flame detector aspects but could be PCB fault.

If PCB its often just an o/c 1 M resistor in series with the detector but for most people than means a new PCB.

You may need a competent CORGI.

Tony