A friend of mine recently had an issue where the flat above his had a leak. This water eventually came through his ceiling and amongst other damage, it affected his light fitting which was quite close to the spot of the leak. The light was flickering when switched off at the wall switch. Switching the light on seemed fine but it was flicking when the switch was in the off position.
I considered, switching off the lighting circuit at the board but all the lighting was being run from a single breaker. I assumed the issue was being caused by the live feed (presumably at the pendant) coming into contact with water. Does this sound plausible and what would be your advice in such a situation?
Thanks in advance.
I considered, switching off the lighting circuit at the board but all the lighting was being run from a single breaker. I assumed the issue was being caused by the live feed (presumably at the pendant) coming into contact with water. Does this sound plausible and what would be your advice in such a situation?
Thanks in advance.