I am intending to install a 2-gang floor socket in the bedroom.
The socket will be part of the upstairs ring main but the wall in which I wanted to site the socket is an old lat and plaster partition type which is built onto the floor boards and doesn't give any access for the cables to be pulled.
The socket will locate against the skirting board and will be under the bed (head end, will be used to bedside lamps etc) obviously not in a walk area so no trip hazard. I was looking at the ones with a sprung flap. Also I would ask the carpet fitter to fit around the socket using the normal gripper rods, so the carpet will not be near the socket.
This seems feasible to me can anyone offer advice ?
The socket will be part of the upstairs ring main but the wall in which I wanted to site the socket is an old lat and plaster partition type which is built onto the floor boards and doesn't give any access for the cables to be pulled.
The socket will locate against the skirting board and will be under the bed (head end, will be used to bedside lamps etc) obviously not in a walk area so no trip hazard. I was looking at the ones with a sprung flap. Also I would ask the carpet fitter to fit around the socket using the normal gripper rods, so the carpet will not be near the socket.
This seems feasible to me can anyone offer advice ?