Hi all,
Had my GD48 installed since March, every so often I’d get 003 Lid tamper alarm, extract below from self mon.
Last month, i finally got around to having a look. I thought perhaps I had a faulty tamper switch so I disconnected the lid tamper switch from the board and just made a loop on the contacts on the board. This seemed to stop it happening until this morning so it appears I may have a fault in my board as it thinks there’s a tamper event.
anybody seen this before? Any ideas? Really hoping i haven’t got to do a board swap!
Had my GD48 installed since March, every so often I’d get 003 Lid tamper alarm, extract below from self mon.
MSG#6670 HOME 06:58:00
Evnt= Tamper alarm. An alarm equipment enclosure opened or tampered with. Zone: 0003
Xtra= +LID TAMP .
Dev= 0.
Grp= 0.
Last month, i finally got around to having a look. I thought perhaps I had a faulty tamper switch so I disconnected the lid tamper switch from the board and just made a loop on the contacts on the board. This seemed to stop it happening until this morning so it appears I may have a fault in my board as it thinks there’s a tamper event.
anybody seen this before? Any ideas? Really hoping i haven’t got to do a board swap!