I've installed a belfast sink base and sink, and added end support panels either side of base (all b&q). At present, the worktop would sit on the end support panels and be 2-3mm above the ceramic belfast sink (and not actually sitting on it). Is this a sufficient enough gap between sink and worktop or should it be more? Also is this gap finished off by filling with silicone?
Gap size between worktop and Belfast sink?
- Thread starter mazears
- Start date
Sponsored Links
Thanks 'big-all' but i was refering to the gap between top of back edge of belfast sink and underside of granite worktop. I think the 12mm you refer to is for the overhang of the worktop past the inner edge of the belfast sink?
Sponsored Links
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
