Hi prob something real simple for someone out there. I have a landing light with a switch either side of the landing and one at the bottom of the stairs. I just wanted to replace the light switch which was fine on one side on the landing as it was like for like and that is ok with me. However the other side must have an older switch on it. I have one cable coming from the top and one from the bottom, they both contain red, blue and yellow wires. The two yellows are connected via a choc block and the switch had two holes at the top labelled L1 where one red and one blue went into separately and the bottom had two holes labelled L2, once again one red and one blue went into these. The switch must be old, I am really not sure what goes where as my new one has L1, L2 and COM.
My initial instinct was to wrap the two that went into L1 together and do the same below but I don't think putting red and blue together would be right. Also I would then have nothing to put into COM! Please can somebody offer some advice, my daughter is crying as the landing light isn't on! lol
My initial instinct was to wrap the two that went into L1 together and do the same below but I don't think putting red and blue together would be right. Also I would then have nothing to put into COM! Please can somebody offer some advice, my daughter is crying as the landing light isn't on! lol