New 2 ch Hive unit, separate boiler and hot water system
Current system is a UP2 + WR1
Have followed advice from 2 previous threads about removing the WR1 yet on both occasions the Heating works, the Hot water doesn't. so either my current UP2/WR1 install is slightly different or i'm making a mistake.
first tried, removing the WR1 from the circuit loop by joining terminals 1 and 3
second, removed the WR1 connections from the main terminal block and moving the brown cable from 4 to 3.
both of those recommendations were from previous posts yet the hot water didn't come on.
WHAT HAVE I DONE WRONG...?
The WR1 Block is the one with the coloured cables, the UP2 block is the one with all black cables.
The picture for the main block has cables 2 and 3 removed (as i hadn't yet put them back when i took the picture)
Thanks for any advice in advance.
Current system is a UP2 + WR1
Have followed advice from 2 previous threads about removing the WR1 yet on both occasions the Heating works, the Hot water doesn't. so either my current UP2/WR1 install is slightly different or i'm making a mistake.
first tried, removing the WR1 from the circuit loop by joining terminals 1 and 3
second, removed the WR1 connections from the main terminal block and moving the brown cable from 4 to 3.
both of those recommendations were from previous posts yet the hot water didn't come on.
WHAT HAVE I DONE WRONG...?
The WR1 Block is the one with the coloured cables, the UP2 block is the one with all black cables.
The picture for the main block has cables 2 and 3 removed (as i hadn't yet put them back when i took the picture)
Thanks for any advice in advance.