Remove the hive and put both wires from terminals 1&3 into the same terminal and the boiler will come on, you can then turn the heating on and off at the boiler manually untill you get the hive sorted
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Hive receiver goosed
- Thread starter kristoffer10
- Start date
Thanks Ian, just for clarity do the wires go into terminal 1 or terminal 3? Also, how tricky a job is this for a novice? Any prep that should be done in advance?
Doesnt matter which one , you are just shorting out the damaged hive, 2 second job just make sure you isolate the power before doing it . a simple screwdiver is all that is needed
Would this loose cable under the boiler be causing the problem? Also under the front panel of the receiver things look fine (images attached)
D
Deleted member 267285
I doubt it would, it’s the earth/cpc wire.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Similar threads
