Hi,
Have a newish Accenta alarm system, self installed, with a Honeywell AG6 bell box.
It all works well, but yesterday needed to remove a PIR for decorating, but found that if I powered the control unit off and disconnected the battery then the Bell box alarm sounds.
While I could disconnect the PIR while 'hot' its not a good way, but reading the manual cannot see a way to power off Quietly, short of geting the ladders out to jumper the bell box off.
any ideas ..?
Have a newish Accenta alarm system, self installed, with a Honeywell AG6 bell box.
It all works well, but yesterday needed to remove a PIR for decorating, but found that if I powered the control unit off and disconnected the battery then the Bell box alarm sounds.
While I could disconnect the PIR while 'hot' its not a good way, but reading the manual cannot see a way to power off Quietly, short of geting the ladders out to jumper the bell box off.
any ideas ..?