ive got a galaxy g2 that i had to replace a bad battery on and the tamper has activated and wont allow me to set the system as i need the enginner code. the missus is after me to get it sorted. i have the installation manual. if anyone can help me reset it back to factory defaults i would be grateful. thanks
remove mains
remove battery
put a link between 0v and tamper on the siren out pins on the pcb
remove connections to zone 1 (1001)
defeat panel tamper switch, put the end station panel screw in place
then power the panel up bay battery first then mains.
When i enter 1234 all I get is invalid code?
enter default code 1234 (or12345)
this should silence the system
then ESC
then enter default engineers code 1122 or 112233 depends on software version
then ENT
enter engineer code again that should default back to factory
BE AWARE BY DOING THIS YOU NOW HAVE TO REPROG THE WHOLE SYSTEM