Hi Folks
I needed some advice about the best way to go about replacing a PIR sensor.
My steps were going to be:
1. Put the panel in engineer mode
2. Remove the mains power from the panel
3. Remove the F2 AUX 500ma glass fuse from the mainboard.
My questions are:
1. Do I disconnect the backup battery from the panel also if I've removed the AUX fuse?
2. If I remove the AUX fuse, will my keypad still stay powered up and in engineer mode?
3. Is there anything else I've missed out?
Thanks in advance for any advice.
Dearly appreciated
AmzWag
I needed some advice about the best way to go about replacing a PIR sensor.
My steps were going to be:
1. Put the panel in engineer mode
2. Remove the mains power from the panel
3. Remove the F2 AUX 500ma glass fuse from the mainboard.
My questions are:
1. Do I disconnect the backup battery from the panel also if I've removed the AUX fuse?
2. If I remove the AUX fuse, will my keypad still stay powered up and in engineer mode?
3. Is there anything else I've missed out?
Thanks in advance for any advice.
Dearly appreciated
AmzWag