- Joined
- 11 Jan 2004
- Messages
- 170
- Reaction score
- 4
- Country
Hello,
I have a framing machine that uses two micro switches buttons that have to be pushed at same time to operate. This keeps hands out of way of blades.
They are faulty and I need to replace. I have located where the two wires from each micro switch go and these look like push in connectors ?
I am attaching a photo of one of the micro switches two cables in these "holes"/ connectors. The grey one directly above the upside down 25 in photo and the black one above the grey one. I notice that there is a square hole beneath each connector, is that for something to be pushed into to release wire ?
Any advice very welcome
Thanks
James
I have a framing machine that uses two micro switches buttons that have to be pushed at same time to operate. This keeps hands out of way of blades.
They are faulty and I need to replace. I have located where the two wires from each micro switch go and these look like push in connectors ?
I am attaching a photo of one of the micro switches two cables in these "holes"/ connectors. The grey one directly above the upside down 25 in photo and the black one above the grey one. I notice that there is a square hole beneath each connector, is that for something to be pushed into to release wire ?
Any advice very welcome
Thanks
James