Hi, I've fitted some LED strips in my bathroom in a ceiling recess and below the sink cabinet. They're 12v and 6 watts per foot, and I have 16ft so about 90watts in total. I've wired them to a remote 150w driver.
They're IP65 rated along the length, but obviously either end is exposed copper to solder the wires on, and when you cut them, again you end up with small bits of exposed copper. I've heatshrinked the ends but it's not going to be waterproof to condensation.
Am I at risk of getting an electric shock from 12v 150w?
They're IP65 rated along the length, but obviously either end is exposed copper to solder the wires on, and when you cut them, again you end up with small bits of exposed copper. I've heatshrinked the ends but it's not going to be waterproof to condensation.
Am I at risk of getting an electric shock from 12v 150w?