LED Light Flashing

[Jamie D]

Yes it is when switched on. Usually they are fine for 10-15 minutes. I have had the covers off for a while now so that hasn’t helped.

I may try some new bulbs then. At least that would hopefully rule out one potential issue.

 

[333rocky333]

Have you tried reversing the tube from end to end, is there any markings on the tube regarding the supply end

 

[Jamie D]

Yes I did. They don’t seem to be labelled with a specific end, but yes have tried both ways.

 

[333rocky333]

The only thing then that i can suggest is someone testing the voltage at the fitting, some tubes like that are only rated at 220 to 240 volt a lower voltage could affect there operation, it seems unlikely, to have 2 faulty tubes, unless as Eric says the heat has affected them, though it appears that the fitting and tubes are compatible.

 

[Jamie D]

Thanks for all the advice. I have just ordered one new bulb, not too much wasted if it doesn’t work. I’ll also try get hold of a voltage tester to see it measure at the fitting.

 

[Jamie D]

New bulb did not fit, despite being (apparently) the right size.

I will try get the voltage tested then see where to go from there.