I bet it was some plastic insert such as these:
https://www.ebay.co.uk/itm/371143123452
https://www.ebay.co.uk/itm/235067644572
https://www.ebay.co.uk/itm/371143123452
https://www.ebay.co.uk/itm/235067644572
M6 nut fitting for bracket
- Thread starter hifly2000
- Start date
These have to be clipped in from the rear so, as the OP says it is an enclosed box section they will not be suitable.
racks for audio gear etc use these. A music shop might have them, You can buy stainless and no doubt Amazon have them.
just make sure that the metal around the hole is ok.
The OP needs the type linked by Stivino (#13), and JohnD (#3). Used hundreds of these in fabrication work.
Or these by MM666 might work.
I bet it was some plastic insert such as these:
https://www.ebay.co.uk/itm/371143123452
- Joined
- 22 Jul 2016
- Messages
- 6,176
- Reaction score
- 1,158
- Country
No they don’t.
you can push them in from the front.
big fat screwdriver
you can push them in from the front.
big fat screwdriver
Not sure if Mr MOT man would be impressed but you could use a cable tie- poke an end through the round hole, pick it up in the rectangular hole with long-nose pliers, feed through placcie thing and bracket, pull tight.
And yes do something with that rust patch even if its only wire brush and Hammerite
And yes do something with that rust patch even if its only wire brush and Hammerite
- Joined
- 25 Jul 2022
- Messages
- 17,924
- Reaction score
- 1,502
- Country
As long as it is secure and cannot foul any moving parts then Mr MOT man wont be in the least bit bothered by it.Not sure if Mr MOT man would be impressed but you could use a cable tie- poke an end through the round hole, pick it up in the rectangular hole with long-nose pliers, feed through placcie thing and bracket, pull tight.
And yes do something with that rust patch even if its only wire brush and Hammerite
Wasn't sure about that given its a part of the braking system...
- Joined
- 25 Jul 2022
- Messages
- 17,924
- Reaction score
- 1,502
- Country
This.....
| Defect | Category |
|---|---|
| (a) Electrical wiring: (i) insecure or inadequately secured (ii) insecure and in contact with sharp edges or connectors likely to become disconnected (iii) likely to touch hot or rotating parts, drag on the ground or the connectors for braking or steering disconnected | Minor Major Dangerous |
| (b) Electrical wiring: (i) slightly deteriorated (ii) so damaged or deteriorated it is likely to cause a short-circuit (iii) for braking or steering components extremely deteriorated | Minor Major Dangerous |
| (c) Electrical wiring insulation: (i) damaged or deteriorated (ii) heavily deteriorated (iii) in such a condition there is an imminent risk of fire or formation of sparks | Minor Major Dangerous |
