New Boiler installation

Status
Not open for further replies.
Sponsored Links
I don't have the manuals for it yet. Maybe @shambolic could email me copies? But the tests the guy carries out for the benchmark book need an analyser and measuring water flow rates.

Is it ok I screenshot ur comments and send it to him also iv done a little video..a lot of features to understand on the boiler:(
 
Sponsored Links
"Service mode" will enable max and min rate..
Why are you showing a benchmark dated 2013????
You haven't a completed benchmark for this boiler have you????
I can smell BS a mile off , I was gifted with a sixth sense...:)
 
"Service mode" will enable max and min rate..
Why are you showing a benchmark dated 2013????
You haven't a completed benchmark for this boiler have you????
I can smell BS a mile off , I was gifted with a sixth sense...:)
It's obvious he made a mistake on the year bit...instead of 13/03/2017
Im sure it can happen to any plumber
 
Just saw this!!! Normally well over 100-200 ppm on a vogue on max rate.
Where's the low? Figures probably plucked out of thin air.
No sham , the figures are from a benchmark dated 2013 FFS..:ROFLMAO::ROFLMAO::ROFLMAO:
The ratio figure actually stacks up with the CO2/CO..
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Status
Not open for further replies.
Sponsored Links
Back
Top