I've cut down a couple of newell base's and bored a hole ready for new newell posts ,but i need to know the best way to round the corners of the base .Is it best to use a file or surform ,or use a coping saw and then sand.
newell base
- Thread starter markbam
- Start date
Sponsored Links
I
imamartian
If it were me (and i'm not an expert), i'd make a template out of a bit of ply, use a nice sharp surform, and a few grades of sand-paper. I'd also have a practice beforehand too.... good luck.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
