The RKPs gave a jingle and the message "System Alert", while the system was unset.
I ran Wintex using the ComIP connection to check the system log, but it failed to connect. I've checked the LAN cable, and the router says the panel is connected as usual.
I checked the log using the RKP and it showed no event between the last unsetting a few hours before, and entering the engineer code.
Could a failure of the ComIP module have caused the Alert?
I ran Wintex using the ComIP connection to check the system log, but it failed to connect. I've checked the LAN cable, and the router says the panel is connected as usual.
I checked the log using the RKP and it showed no event between the last unsetting a few hours before, and entering the engineer code.
Could a failure of the ComIP module have caused the Alert?