Old PIR reuse with Texecom Premier Elite

[MM456]

Hi,

I'm looking to connect existing wired PIRs in to a new Texecom Premier Elite 48 panel. The current PIRs have resistors which can be changed with jumpers (currently set as 4k7 for Tamper and 6k8 for Alarm - see attached).

When connected to the Texecom panel and configuring in Wintex, should I configure the zone as Double Pole/EOL or change the resistor value in the PIR to 2k2 for Tamper and 4k7 for alarm and then set in Wintex as 2k2/4k7/(6k8)?

Thanks in advance.

 

[sparkymarka]

No set them as 4.7k / 6.8k in wintex ( gardtec ) or change the jumper setting ..

 

[MM456]

Perfect. Thanks