- Joined
- 1 Jun 2017
- Messages
- 193
- Reaction score
- 3
- Country
I have one of these type external junction boxes fitted as part of a security light setup for the house.
https://www.toolstation.com/junction-box-ip65/p99418
Stupidly I tore all the rubber out one of the side entries, rather than the specific cutout that leaves a bit of a rubber seal.
With a gland fitted, there are nowanow few little gaps where water could get in.
Is this something to worry about? I made a hole in the bottom entry so in theory, worst case it did fill with water it could drain out this hole.
Cheers.
https://www.toolstation.com/junction-box-ip65/p99418
Stupidly I tore all the rubber out one of the side entries, rather than the specific cutout that leaves a bit of a rubber seal.
With a gland fitted, there are nowanow few little gaps where water could get in.
Is this something to worry about? I made a hole in the bottom entry so in theory, worst case it did fill with water it could drain out this hole.
Cheers.