Hi there.i am wanting to hang three pendant lights to one switch,joining all the wires in a three terminal four connection junction box.there is only one supply cable in the conservatory void.i have joined all the relevant colours together but no joy.the lights take a screw 100w max bulb and it is a dimmer switch.anybody help.cheers
Pendant lights
- Thread starter Baldypaul
- Start date
Sponsored Links
Hi, picutres of your work would help. Have you checked the connections at the first light(where the mains feed is) ?
Make sure you have copper on cooper and have removed enough insulation.
Check your connections at the dimmer COM =mains L , L1=feed to light.
Regards,
DS[wiki][/wiki]
Make sure you have copper on cooper and have removed enough insulation.
Check your connections at the dimmer COM =mains L , L1=feed to light.
Regards,
DS[wiki][/wiki]
Where is this junction box?
I can't see a need for a junction box in the conservatory 'void'. That's just going to cause aggro later on.
Did the cable in the void not have any power to it then?
Is the cable connected at the switch?
Is there a fused spur connection unit somewhere that's not connrcted/switched off/fuse removed?
I can't see a need for a junction box in the conservatory 'void'. That's just going to cause aggro later on.
Did the cable in the void not have any power to it then?
Is the cable connected at the switch?
Is there a fused spur connection unit somewhere that's not connrcted/switched off/fuse removed?
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
Sponsored Links
