- Joined
- 25 Nov 2019
- Messages
- 2
- Reaction score
- 0
- Country
Hi,
I am going to install a Hive Dual Active system in my house. Currently the boiler is controlled by a Potterton EP2002 unit. I've taken it off and I'm a little bit confused by the wiring required on the receiver. Picture is here: https://share.icloud.com/photos/0tqL53UCJJtZpU8mVXX8jtR0A
I've read on this forum that the link between terminal 5 and the permanent live is not required and that's fine, but it seems then I would only have two wires (3 and 4). The Hive install guide suggests I need to have 4 - HW On/Off and CH On/Off.
Any suggestions?
Stuart
I am going to install a Hive Dual Active system in my house. Currently the boiler is controlled by a Potterton EP2002 unit. I've taken it off and I'm a little bit confused by the wiring required on the receiver. Picture is here: https://share.icloud.com/photos/0tqL53UCJJtZpU8mVXX8jtR0A
I've read on this forum that the link between terminal 5 and the permanent live is not required and that's fine, but it seems then I would only have two wires (3 and 4). The Hive install guide suggests I need to have 4 - HW On/Off and CH On/Off.
Any suggestions?
Stuart