I’m having a few problems with my boiler,
Problem (1) I am not getting a proper HW supply, the water is running at normal pressure but is only just warm, because the flame on the boiler does not go to full flame but stays low, if I turn the flow down at the tap to 1 pint / 10 seconds the water is hot (but this would take days to run a bath)
Problem (2) probably connected to problem (1).
When the CH comes on it is supposed to go to full flame after 2 minutes but never does and the pump is running OK but does not manage to get the heat to the last radiator in the system, (have bled this radiator which eventually gets it hot but back cold next time).
I would most grateful if any of you Potterton Guru’s can give me a clue.
Problem (1) I am not getting a proper HW supply, the water is running at normal pressure but is only just warm, because the flame on the boiler does not go to full flame but stays low, if I turn the flow down at the tap to 1 pint / 10 seconds the water is hot (but this would take days to run a bath)
Problem (2) probably connected to problem (1).
When the CH comes on it is supposed to go to full flame after 2 minutes but never does and the pump is running OK but does not manage to get the heat to the last radiator in the system, (have bled this radiator which eventually gets it hot but back cold next time).
I would most grateful if any of you Potterton Guru’s can give me a clue.