I have a plasterer coming out in the next week to plaster a porch, it has a porch light and light switch in it which I need to remove and make safe, then reinstate once the job is done. The house was re-wired a few years back and I know all down stairs light are on the same ring circuit.
Would it be sufficient for me to turn off the ring circuit, remove the light fitting and then tape/chocbox the bare wire ends until work is finished and then reinstate?
The plasterer will be in the house of two mornings, so I will be looking to switch the ring circuit back on between visits.
Would it be sufficient for me to turn off the ring circuit, remove the light fitting and then tape/chocbox the bare wire ends until work is finished and then reinstate?
The plasterer will be in the house of two mornings, so I will be looking to switch the ring circuit back on between visits.