Pyronix enforcer v10 bell triggers when setting alarm

Joined
12 Jan 2020
Messages
7
Reaction score
0
Country
United Kingdom
Hi

I've installed a pyronix enforcer v10 with a deltabell. When I set the system the bell goes off. I have two PIRs and a door sensor installed and paired. I've checked the tamper on the bell box and it only clicks as I lift the box cover.

Tony
 
Sponsored Links
Have you messed with outputs ...?
Change outputs / wireless bell / bell o/p
What does it say ? Should be siren any
 
Sponsored Links
It says
BELL O/P (0014)
Siren Any

Then the next one says
STB O/P (0016)
Strobe Any

PGM O/P (0000)
Not Used
 
That’s ok
Set system but keep still near keypad ....what does it say when the bell goes off ?
Do you get long set tone ?
 
It doesn't say anything, I get the final bleep the indicate set, then bell ring and not reading on keypad.
 
I may have to take the box back off and see if its being affected by other wifi.
 
Ok check outputs again but this time check endstation output ....bell output ....should be any siren
 
All set ok, now when i deactivate after an activation it say - alarm silences restore required?
 
20200112_145422.jpg
 

DIYnot Local

Staff member

If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.

Select the supplier or trade you require, enter your location to begin your search.


Are you a trade or supplier? You can create your listing free at DIYnot Local

 
Sponsored Links
Back
Top