Hi
Just installed a Pyronix enforcer system with 3 KX10DP pir's.
All the system was fine when I bench programmed and tested it but now the pir's are in the rooms they don't seem to trigger as expected if at all during the walk test.
Living room one is fitted in a corner 2.3m from the floor scanning all the room and through an arch into the dinning room, second one is in the dining room again 2.3m from the floor scanning this room and into the extension.
I know they work and placed them where the old system pirs were.
I have tried putting them into lower mode but its still the same.
Any ideas?
Cheers
Just installed a Pyronix enforcer system with 3 KX10DP pir's.
All the system was fine when I bench programmed and tested it but now the pir's are in the rooms they don't seem to trigger as expected if at all during the walk test.
Living room one is fitted in a corner 2.3m from the floor scanning all the room and through an arch into the dinning room, second one is in the dining room again 2.3m from the floor scanning this room and into the extension.
I know they work and placed them where the old system pirs were.
I have tried putting them into lower mode but its still the same.
Any ideas?
Cheers
Last edited: