Is it ok to put a 22/15mm reducer straight in to a 22mm compression. Is there enough 22mm pipe for the olive to bite up to?
reducer straight in compression fitting?
- Thread starter tomsim
- Start date
Yes, but make sure the shoulder of the fitting isn't pushed past the outer face of the nut.
Yep, use a little jointing compound for good measure
If the shoulder of the reducer is not within the olive when its fully seated then it will be OK
Could you explain more please?
When you push the reducer into the fitting, pull it out just a Little so that the shoulder is just past the nut
When you offer the fitting in, it will become clear
Indeed.
Thought he meant a 15/22 end feed reducer ?
+1 
Yup, I was thinking that way too but it could be either I suppose.
If it is an end feed reducer then make sure the shoulder, top arrow, is out beyond the end of the compression nut, lower arrow. that way olive will be centered on the 22mm sized area ( guess what bit
)
View media item 68946
If it is an end feed reducer then make sure the shoulder, top arrow, is out beyond the end of the compression nut, lower arrow. that way olive will be centered on the 22mm sized area ( guess what bit
)View media item 68946
Will they not seal if the reducer is pushed all the way in?
Of course it will. 
That's why we're telling you NOT to push it too far.
That's why we're telling you NOT to push it too far.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
