Release Locktite 243

[pidgeon1]

How do I release locktite 243 on a brass thread ?

tried holding with pliers and spanner other end does not want to move.

 

[Burnerman]

The secret with chemical thread lockers is to apply heat, allowing it to soak right into the join of the threads.
It needs to be quite substantial heat - as per a propane torch flame maybe - if you have one. Red heat isn't necessary, of course!
John

 

[pidgeon1]

The secret with chemical thread lockers is to apply heat, allowing it to soak right into the join of the threads.
It needs to be quite substantial heat - as per a propane torch flame maybe - if you have one. Red heat isn't necessary, of course!
John

Can't do heat its on a hose pistol grip . it would melt this

 

[pidgeon1]

Can't do heat its on a hose pistol grip . it would melt this

Is there a solvent I could use ?

 

[Mike13]

MEK? might just soften it, use a dropper to add a small amount at a time

 

[just pumps]

That is meduim strength, you might need two people and a hammer to shock / break the seal.

 

[Burnerman]

The end you are holding with pliers......any chance of holding it in a vice, or using mole grips maybe?
John