Hello, readers! My first post, so hope this makes sense.
I have an immersion heater for a hot water cylinder connected to a fused spur (I believe this is correct, but I am no expert on terminology). Looks like this:
http://www.tlc-direct.co.uk/Products/BG950.html
It is now connected to the immersion heating element via a 24 hr timer like this:
http://www.tlc-direct.co.uk/Products/TCTI24.html
The hot water cylinder with the timer and the switch is located in a cupboard in the bedroom. So, what I am trying to do now is to install a remote switch (pull-cord type) somewhere nearer or even in the bathroom to switch the immersion on/off. The timer is seldom used, and prefer to just switch on the immersion to top up the hot water before showering.
Suggestions on how this can be wired up?
Thanks for reading.
I have an immersion heater for a hot water cylinder connected to a fused spur (I believe this is correct, but I am no expert on terminology). Looks like this:
http://www.tlc-direct.co.uk/Products/BG950.html
It is now connected to the immersion heating element via a 24 hr timer like this:
http://www.tlc-direct.co.uk/Products/TCTI24.html
The hot water cylinder with the timer and the switch is located in a cupboard in the bedroom. So, what I am trying to do now is to install a remote switch (pull-cord type) somewhere nearer or even in the bathroom to switch the immersion on/off. The timer is seldom used, and prefer to just switch on the immersion to top up the hot water before showering.
Suggestions on how this can be wired up?
Thanks for reading.