Hi Guys,
I have just taken two rads off so I can decorate. I am having a real problem doing the tail nuts back up onto the TRV’s. both are Honeywell. The rad position relative to the TRV on both is fine. When you tighten the nuts it seems that it is biting for a couple of rotations then the nut just slips then you are back to square one.
I thought it was something funny with the first rad but as the second one is doing it clearly I have missed something here. Taken plenty of rads of in the past but none had TRVs
What have I missed? I do feel quite stupid on this one.
Thanks for your help
David
I have just taken two rads off so I can decorate. I am having a real problem doing the tail nuts back up onto the TRV’s. both are Honeywell. The rad position relative to the TRV on both is fine. When you tighten the nuts it seems that it is biting for a couple of rotations then the nut just slips then you are back to square one.
I thought it was something funny with the first rad but as the second one is doing it clearly I have missed something here. Taken plenty of rads of in the past but none had TRVs
What have I missed? I do feel quite stupid on this one.
Thanks for your help
David