Hi,
I wonder if you chaps can give me a little advice.
My front door has a cylinder rim lock on it. The cylinder bit is made by HD and the rim lock bit on the inside is made by chubb. It is obviously a mix and match affair and the key we have for the HD cylinder does not fit in the Chubb rim lock and the whole thing it a bit loose and tatty.
I am going to replace it but would obvious like to use the same hole for the lock cylinder - Is the spacing of this hole from the edge of the door universal? OR will I have to hunt around for the right lock to match up with the old hole?
Cheers
Sam
I wonder if you chaps can give me a little advice.
My front door has a cylinder rim lock on it. The cylinder bit is made by HD and the rim lock bit on the inside is made by chubb. It is obviously a mix and match affair and the key we have for the HD cylinder does not fit in the Chubb rim lock and the whole thing it a bit loose and tatty.
I am going to replace it but would obvious like to use the same hole for the lock cylinder - Is the spacing of this hole from the edge of the door universal? OR will I have to hunt around for the right lock to match up with the old hole?
Cheers
Sam