Hi looking for advice. I have a Bosch POF 1400 router and was thinking about making a cheap table for it. I have a piece of 40mm worktop would this be OK for making the table top? I thought if I cut it to size and fix a hardwood trim around it I could buy an insert, Kreg probably, and route out a rebate for it then fit the whole lot onto a beefed up kitchen cabinet or something similar ? For a fence I could just use a straight edge and a couple of clamps.
-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
router table
- Thread starter jwpzx9r
- Start date
D
Deleted member 174758
Yes it will do, but do check that it isn't cupped across the width to start with - worktop material has a temndency to cup because being laminated on only one side it is out of balance. If it isn't and is fairly new then seal the bottom face with something like old gloss paint to prevent future cupping
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
