Hi all
I have a scantronic 9448 that was installed about 15 years ago. It has 3 zones and a separate entry/exit zone. We have 6 pirs and 1 door contact.
Over the years we have had our house upgraded and had more pir's installed. I am looking to replace the panel and have realised that the different alarm installers have wired more than 1 pir to one zone and have made the connections somewhere in the ceiling void. So in our panel, we have 5 wires, 1 bell box and all 4 zones. Non of the Pir's are latching, so its a real pain to find out which one has activated. we have 2 pirs on zone 1, 3 on zone 2 and one on zone 3, which we omit for on a night.
So here's my question, is it possible to wire each pir to a separate zone on a new panel or would it be a costly job for an engineer.
P.S all the pirs are new and any recomendations on a good panel?
Any help would be appreciated
Josh
I have a scantronic 9448 that was installed about 15 years ago. It has 3 zones and a separate entry/exit zone. We have 6 pirs and 1 door contact.
Over the years we have had our house upgraded and had more pir's installed. I am looking to replace the panel and have realised that the different alarm installers have wired more than 1 pir to one zone and have made the connections somewhere in the ceiling void. So in our panel, we have 5 wires, 1 bell box and all 4 zones. Non of the Pir's are latching, so its a real pain to find out which one has activated. we have 2 pirs on zone 1, 3 on zone 2 and one on zone 3, which we omit for on a night.
So here's my question, is it possible to wire each pir to a separate zone on a new panel or would it be a costly job for an engineer.
P.S all the pirs are new and any recomendations on a good panel?
Any help would be appreciated
Josh