I’ve recently purchased an i-FB01 remote to replace a 2W-4B remote which has stopped working.
The setup I have is a few PIR’s and a door sensor on the front door for the final door setting.
When pressing set on the old remote I just heard two beeps from the control unit and the alarm was set, this was used when exiting using any door other than the front door.
Since adding the new remote pressing set triggers the final door setting which is useless when I’m already outside.
Is there a way to change this setting so that the alarm just sets without the final door setting?
Thanks
The setup I have is a few PIR’s and a door sensor on the front door for the final door setting.
When pressing set on the old remote I just heard two beeps from the control unit and the alarm was set, this was used when exiting using any door other than the front door.
Since adding the new remote pressing set triggers the final door setting which is useless when I’m already outside.
Is there a way to change this setting so that the alarm just sets without the final door setting?
Thanks