I'm thinking of fixing up a body drier in my shower. This would basically be a fan heater (with a thermostat to prevent burns) and would only operate after the water is switched off.
The idea is to cut down on towels etc. and also to stop the shower cubicle getting mouldy. I need some advice on how to wire the changeover switch so that the heater can't operate while the shower's on, and vice versa.
Also what IP rating does the fan heater need to be?
Don't worry I know all about Part P, special locations etc. and a cousin of mine knows someone who can make all the connections, do the cross bonding etc.
Any advice gratefully received.
The idea is to cut down on towels etc. and also to stop the shower cubicle getting mouldy. I need some advice on how to wire the changeover switch so that the heater can't operate while the shower's on, and vice versa.
Also what IP rating does the fan heater need to be?
Don't worry I know all about Part P, special locations etc. and a cousin of mine knows someone who can make all the connections, do the cross bonding etc.
Any advice gratefully received.