My mitre saw has several set angles which it locks to, trouble is when it is set at 45 degrees it isn't as accurate as I would have hoped
I have set the 0 degrees by using an accurate square ( tested at work for squareness ) and by moving the fence a tad it cuts true, but the 45 degree cut is more like 44...not good when you are trying to make a square frame.
I see the only option open to me is to file the 45 degree locator slots, I've had the saw too long to take it back
It's a poor workman that blames his tools, next time I will have to save up more money and buy a decent saw
I have set the 0 degrees by using an accurate square ( tested at work for squareness ) and by moving the fence a tad it cuts true, but the 45 degree cut is more like 44...not good when you are trying to make a square frame.
I see the only option open to me is to file the 45 degree locator slots, I've had the saw too long to take it back
It's a poor workman that blames his tools, next time I will have to save up more money and buy a decent saw