solvent weld waste converted to push fit

[rick85]

Morning all,

Could anyone advise on how to convert solvent weld (32mm) to push fit (32mm) pipe??

Is there a straight forward part or do you have to use compression parts?

If you could provide a link to the appropriate part, I would be grateful

Thanks[/i]

 

[kirkgas]

the only way to do it is to use a compression fitting, there are many on the market, but without doubt the best by a long way is a McAlpine "MULTIFIT" connector, straight or bend depending on what you need, B&Q etc sells equivelant but they are no where near the quality of McAlpine, worth the extra
http://mcalpineplumbing.com/

 

[BingoBongo]

the push fit stuff is a different size so yes you would have to use a compression

 

[rick85]

thank you for the advice all.

Cheers.