Stripping wire

[leeco]

I have got a lot t&e building up and was thinking of making a wood block with razor blades to strip it all down.

Is there a tool to do this?

My idea in my head should work but I would just buy a tool if there was one.

 

[Johnmelad]

https://www.youtube.com/watch?v=1SFbk9kn0lk[youtube][/youtube]

 

[leeco]

I'm getting the welder out thanks.

 

[sparkwright]

To be honest, some of these ideas are just too dangerous for the sake of a bit of scrap money.

Accidents waiting to happen.

Shouldn't be on a DIY forum, should remove thread.

 

[leeco]

It's not just a little bit of scrap money if you have loads and a big difference in price if it's stripped.

Making something like that in the YouTube vid isn't dangerous Infact it takes away a lot of danger stripping wire as I have sliced my hand and leg oped in the past stripping wire.

 

[JohnW2]

It's not just a little bit of scrap money if you have loads and a big difference in price if it's stripped.

The price difference diminishes appreciably if you cost in the time it takes you to strip it, 'at your usual rates'.

Kind Regards, John

 

[sparkwright]

It's not just a little bit of scrap money if you have loads and a big difference in price if it's stripped.

The price difference diminishes appreciably if you cost in the time it takes you to strip it, 'at your usual rates'.

Kind Regards, John

I tend to agree. I have loads of scrap, but I'm still not going to waste my time stripping it.

 

[leeco]

It's not just a little bit of scrap money if you have loads and a big difference in price if it's stripped.

The price difference diminishes appreciably if you cost in the time it takes you to strip it, 'at your usual rates'.

Kind Regards, John

True.

I hate stripping the stuff.