-
Looking for a smarter way to manage your heating this winter? We’ve been testing the new Aqara Radiator Thermostat W600 to see how quiet, accurate and easy it is to use around the home. Click here read our review.
Studding wall with pipes for mixer bar shower
- Thread starter mrbg07546
- Start date
Studs run from the bottom plate to the top plate in one single length.
Your corner studs are a concoction of bits and pieces.
Presumably any other inside corner has been constructed in the same haphazard way?
Pull the corners and do it properly with full studs in plane with two sides.
Your inside corners must be perfectly at 90 degrees and spot on plumb.
You can use the 2 x 4 off-cuts as backing to pick up where the boards meet at the corner - google footprints of stud framing inside corners.
What about the backing studs for boards and enclosure jambs - have they been doubled up?
Why not post pics of the whole framing arrangement - if you go ahead with what you've got it probably wont work, and could be an expensive lesson.
Your corner studs are a concoction of bits and pieces.
Presumably any other inside corner has been constructed in the same haphazard way?
Pull the corners and do it properly with full studs in plane with two sides.
Your inside corners must be perfectly at 90 degrees and spot on plumb.
You can use the 2 x 4 off-cuts as backing to pick up where the boards meet at the corner - google footprints of stud framing inside corners.
What about the backing studs for boards and enclosure jambs - have they been doubled up?
Why not post pics of the whole framing arrangement - if you go ahead with what you've got it probably wont work, and could be an expensive lesson.
DIYnot Local
Staff member
If you need to find a tradesperson to get your job done, please try our local search below, or if you are doing it yourself you can find suppliers local to you.
Select the supplier or trade you require, enter your location to begin your search.
Are you a trade or supplier? You can create your listing free at DIYnot Local
